Sea Side Aquatics
Simply The Best
Author Archives: Sea Side Aquatics
- 09/2017
-
- 09/2017
-
Bubble Magus Bio-Spheres Balls
Category : Misc , Misc. News , Your Choice Aquatics
Comes with Zipper Mesh Bag, approximately 1 pound
Perfect for aquarium, pond and reef
1 pound is roughly equivalent to 44 pound of live rock.
Made in Taiwan
- 09/2017
-
Bubble Magus Sump Filter
Category : Bubble Magus , Other Filters / Reactors
The filter is a high-efficiency water filtration system which effectively removes suspended particles such as detritus, food, organic waste from the water column.
Use in marine aquariums, freshwater aquariums and corals system.
12″ long x 15.5 wide by 14″ tall
Bubble Magus ARF-1 Auto Roll Filter
ARF-1 Specifications
• 12v DC motor
• 110v Power adapter ULc DC12v 1amp output
• Water level switch
• Filter roll Non woven 150mm width, 25M length
• 1” I.D inlet pipe, complete with Flex pipe
• 40x36x26cm total dimensions (including motor body)
• Internal sump mounted
The ARF-1 removes the need for filter socks. Water is fed into the internal chamber via the aquarium systems drain, and through the filter roll. When the water level rises in the chamber due to filter clogging the water level switch triggers the motor to wind on the filter roll to a new fresh piece. The water level will then drop repeating the process
- 09/2017
-
New Angle Black Frag Rack Small and Large Size
Category : Misc , Your Choice Aquatics
Black Color
Hold 8 regular plugs Small, Large hold up to 14 plugs
Up to 1/2″ thick magnetic
4.60″ long x 3″ wide from the wall Small, Large is 7.75″ long
- 04/2017
-
Air Leak In Dosing Container
Category : Bubble Magus , Dosing Pumps , Misc. Products , Sea Side Aquatics
Unfortunately, it has brought up to our attention that there was a air leak in our 1.5L dosing container. The leak was from the side connection, what we found was at the join the glue dried up and left a little air hole. When the dosing unit pull the liquid, air entered from this hole.
Please contact us at seasideaquatics@yahoo.com with any issue
or you can easily prepare it with little silicone.
You can exam the join and see little gap / hole at the join. You can apply little silicone around the join areas, let it dry for about 1-2 hours. This would solve the issue.
You also can remove the connection buy counterclockwise the fitting. Then apply little silicon in the male thread area then screw the fitting back. Let it dry for about 1-2 hours, this would solve the issue.
- 03/2017
-
